How was your Yield the last season?
Growers who use SMART! Software report 20-70% increase in crop yields
"Any formula I can dream of, I can make it happen"
Edward L. Pole, Hydrosystems
A Premier Online Course:
Fertilization & Irrigation - Become an Expert
"Thanks to SMART we increased our tomato yields from 120 to 160 tons/ha"
Piet Weipe, South Africa
"I had more than 40% increase in corn for sillage."
Humberto Estrada Vilegas, Colombia
"SMART! allowed me to save over $8,000 a month by cutting back on fertilizers consumption"
Beny Carmel, Israel
"Incorporating SMART has been like going from an era of carts to cars"
Claudio Katz, farm manager
Get Greater Yields at Lower Costs
"Thanks to SMART, we can now offer a very reliable, soil, leaf & water test results!"
Scott Mckay, Australia
Category - Plant Nutrition
The Essential Plant Nutrients
There are 13 mineral nutrients that are essential for completion of the plant's life cycle. Macro-elements are required in large quantities: nitrogen, potassium, phosphor, calcium, magnesium, sulfur. Micro-nutrients are required in very low concentration: iron, manganese, zinc, copper, molybdenum, boron, chlorine.
All of these nutrients should be provided in the hydroponic nutrient solution, in the right concentrations, and in adequate ratios.
According to the law of "limiting factor" , if one nutrient is deficient, other nutrients cannot compensate for the deficiency, and the crop may suffer, resulting in decreased quality and/or yield.
Nitrogen, phosphorus and potassium
Most water sources contain only very small amount of these nutrients, if at all, therefore they must be provided in the hydroponic nutrient solution using fertilizers.
Commonly used soluble fertilizers are MAP, potassium sulfate, ammonium nitrate, potassium nitrate.
Calcium and magnesium
These nutrients are usually found in source water, sometimes in adequate concentration for plant needs, especially in well-water. If the concentration is higher than required, the source water should be pre-treated.
Calcium nitrate is the only fertilizer appropriate for calcium addition to hydroponic nutrient solution. Magnesium nitrate and magnesium sulfate are both appropriate sources for magnesium addition. Note that calcium nitrate and magnesium nitrate also contribute nitrogen to the hydroponic nutrient solution.
Sulfur is present in a wide range of concentrations in various water sources, and plants grown in hydroponics can tolerate relatively high concentration. But sulfur excess might have untoward effects and even limit nitrate uptake.
Iron, manganese, zinc and copper can be provided in the sulfuric form, but their availability is greatly decrease in pH greater than 6.5. The chelated forms ,may also be used, because they are available for uptake in a wider range of pH (learn more about chelate fertilizers). Some growers regard EDTA as harmful for plants, and avoid its use.
Molybdenum is usually provided using sodium molybdate. The presence of sodium in this fertilizer should not be a cause for alarm. Because molybdenum is needed in minute quantities, very small amounts of this fertilizer are usually used, and the sodium addition is negligible.
Boron can be provided through Boric Acid or Solubor. Solubor also contains sodium, but again, quantities are small enough as to not have a significant effect on sodium concentration in the solution. Range for adequate boron levels is very narrow (0.2-0.5 ppm) and can easily be missed, resulting in either deficiency or toxicity. Therefore boron supplements should be carefully added. Well water often contain sufficient boron levels, so no boron addition is needed.
Add a comment
View comments (2)